User Tools

Site Tools


projects_raspberry_thermalprinter

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

projects_raspberry_thermalprinter [2017/06/18 11:00] (current)
jpk created
Line 1: Line 1:
 +====== Raspberry w/ Thermal Printer ======
  
 +===== /​boot/​cmdline.txt =====
 +<​code>​
 +dwc_otg.lpm_enable=0 console=tty1 root=/​dev/​mmcblk0p7 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait
 +</​code>​
 +
 +===== /​boot/​config.txt =====
 +<​code>​
 +# For more options and information see
 +# http://​rpf.io/​configtxtreadme
 +# Some settings may impact device functionality. See link above for details
 +
 +# uncomment if you get no picture on HDMI for a default "​safe"​ mode
 +#​hdmi_safe=1
 +
 +# uncomment this if your display has a black border of unused pixels visible
 +# and your display can output without overscan
 +#​disable_overscan=1
 +
 +# uncomment the following to adjust overscan. Use positive numbers if console
 +# goes off screen, and negative if there is too much border
 +#​overscan_left=16
 +#​overscan_right=16
 +#​overscan_top=16
 +#​overscan_bottom=16
 +
 +# uncomment to force a console size. By default it will be display'​s size minus
 +# overscan.
 +#​framebuffer_width=1280
 +#​framebuffer_height=720
 +
 +# uncomment if hdmi display is not detected and composite is being output
 +#​hdmi_force_hotplug=1
 +
 +# uncomment to force a specific HDMI mode (this will force VGA)
 +#​hdmi_group=1
 +#​hdmi_mode=1
 +
 +# uncomment to force a HDMI mode rather than DVI. This can make audio work in
 +# DMT (computer monitor) modes
 +#​hdmi_drive=2
 +
 +# uncomment to increase signal to HDMI, if you have interference,​ blanking, or
 +# no display
 +#​config_hdmi_boost=4
 +
 +# uncomment for composite PAL
 +#​sdtv_mode=2
 +
 +#uncomment to overclock the arm. 700 MHz is the default.
 +#​arm_freq=800
 +
 +# Uncomment some or all of these to enable the optional hardware interfaces
 +#​dtparam=i2c_arm=on
 +#​dtparam=i2s=on
 +#​dtparam=spi=on
 +
 +# Uncomment this to enable the lirc-rpi module
 +#​dtoverlay=lirc-rpi
 +
 +# Additional overlays and parameters are documented /​boot/​overlays/​README
 +
 +# Enable audio (loads snd_bcm2835)
 +dtparam=audio=on
 +
 +# NOOBS Auto-generated Settings:
 +hdmi_force_hotplug=1
 +enable_uart=1
 +</​code>​
projects_raspberry_thermalprinter.txt · Last modified: 2017/06/18 11:00 by jpk